Evidence-led vulnerability intelligence · 2026-11-20 11:48 IST

CVE-2026-99744

In the Linux kernel, the following vulnerability has been resolved: net: atl1c: drop oversized RX frames instead of panicking atl1c sizes its receive buffers from the netdev MTU plus a fixed set of L2 overheads, which comes to 1522 bytes at the default MTU. A link partner that sends a longer frame - in practice a MikroTik CCR2004-1G-2XS-PCIe, whose RouterOS side defaults to l2mtu 1600 while the host stays at MTU 1500 - makes the length reported by the RX return descriptor exceed what the hardware wrote, and skb_put() then either includes bytes that were never received or trips skb_over_panic and takes the host down. Compare the descriptor length against buffer_info->length, the length the hardware was given, rather than against skb_tailroom(): the skb carries 64 bytes of slack for the DMA erratum, so tailroom is larger than the DMA buffer and a frame in between would pass the check and still be delivered with a tail the device never wrote. The same test rejects frames shorter than ETH_HLEN + ETH_FCS_LEN; before this change a reported length below ETH_FCS_LEN underflowed in skb_put(). The frame is dropped with kfree_skb_reason(SKB_DROP_REASON_PKT_TOO_BIG) so drop_monitor and the kfree_skb tracepoint see it, and counted through dev_core_stats_rx_dropped_inc(), which survives atl1c_get_stats() overwriting the hardware counters on every read. It also counts as work: atl1c_clean_rfd() has already recycled the RFD, and the refill at the end of the poll only runs when work_done is non-zero, so sustained oversized traffic would otherwise drain the ring and stop RX. Tested on a MikroTik CCR2004-1G-2XS-PCIe (4x AR8151) in a Proxmox VE host, with atl1c built from a DKMS tree carrying this change: the l2mtu-1600 traffic that panics the stock driver is dropped and counted with the patch applied, and received normally once the host MTU is raised to match. This complements commit 36c2009d90f2 ("net: atl1c: fix soft lockup on out-of-range tpd_cons read"), which fixed the TX side of the same "host dies while the card resets" problem.

UNRATED · N/ALinuxNetwork devices

Executive briefing

A structured intelligence assessment has not yet been generated. The source description is shown above. The background enrichment worker will retry this record.

Assessment: Potential exposure only — validate product, version, configuration and vendor applicability.

Evidence confidence: Not assessed Evidence-derived, not an exploitability verdict

Severity & attack characteristics

N/A / 10 ·

CVSS vector:

No CVSS vector is currently available in the source record.

Technical explanation & impact

Technical root-cause details are not available in the current source record.

Assess the impact using the published CVSS metrics and the affected vendor component.

Affected products and versions

NVD has not supplied machine-readable vulnerable CPE product/version entries for this CVE. This is an information gap, not proof that no products are affected. Check the vendor advisory references below.

Remediation & validation

  1. Identify exposure by comparing the affected product and version ranges with your asset inventory, SBOM and externally exposed services.
  2. Review the linked vendor security advisory or patch notes. Upgrade to a vendor-confirmed fixed release; do not infer a fixed version from the CVE description.
  3. Until patched, consider restricting network access or disabling the affected feature where operationally safe. These are temporary controls, not a substitute for a vendor fix.
  4. Validate the remediation with a version check and vulnerability rescan, then retain change evidence.

No fixed version is displayed unless it is explicitly established by a vendor advisory. Follow the vendor's release notes for exact product and branch applicability.

Vendor advisories, patches & exploit references

Open NVD record ← Back to CVE Watch