Evidence-led vulnerability intelligence · 2026-09-24 22:47 IST

CVE-2026-97481

In the Linux kernel, the following vulnerability has been resolved: serial: 8250: fix possible ISR soft lockup There are rare cases in which the host gets stuck in the ISR because it is flooded with messages during the startup phase. The reason for the soft lockup in the ISR is the missing FIFO error IRQ (FIFOE) handling. Not handling it and reporting IRQ_HANDLED triggers the IRQ immediately again. Fix this by adding a check for the FIFOE status and clearing the FIFO if no data is ready (DR). This behavior was observed on an AM62L device which uses the OMAP 8250 driver. Fix it for all 8250 drivers, since the OMAP driver's special IRQ setup handling may trigger this behavior more frequently, but it is not ensured that other 8250 drivers aren't affected.

UNRATED · N/ALinux

Executive briefing

A structured intelligence assessment has not yet been generated. The source description is shown above. The background enrichment worker will retry this record.

Assessment: Potential exposure only — validate product, version, configuration and vendor applicability.

Evidence confidence: Not assessed Evidence-derived, not an exploitability verdict

Severity & attack characteristics

N/A / 10 · CVSS

CVSS vector:
Not supplied

No CVSS vector is currently available in the source record.

Technical explanation & impact

Technical root-cause details are not available in the current source record.

Assess the impact using the published CVSS metrics and the affected vendor component.

Affected products and versions

NVD has not supplied machine-readable vulnerable CPE product/version entries for this CVE. This is an information gap, not proof that no products are affected. Check the vendor advisory references below.

Remediation & validation

  1. Identify exposure by comparing the affected product and version ranges with your asset inventory, SBOM and externally exposed services.
  2. Review the linked vendor security advisory or patch notes. Upgrade to a vendor-confirmed fixed release; do not infer a fixed version from the CVE description.
  3. Until patched, consider restricting network access or disabling the affected feature where operationally safe. These are temporary controls, not a substitute for a vendor fix.
  4. Validate the remediation with a version check and vulnerability rescan, then retain change evidence.

No fixed version is displayed unless it is explicitly established by a vendor advisory. Follow the vendor's release notes for exact product and branch applicability.

Vendor advisories, patches & exploit references

No external references are currently supplied in the CVE record.

Open NVD record ← Back to CVE Watch