CVE-2026-82962
ethernet_fill_header() in subsys/net/l2/ethernet/ethernet.c can prepend the Ethernet header in place, by pushing it into the headroom of the packet's first fragment, instead of allocating a separate header fragment. Before this fix the in-place path was selected purely from the build-time value of CONFIG_NET_L2_ETHERNET_RESERVE_HEADER, with no check that the packet actually has that headroom, and then called net_buf_push(pkt->buffer, hdr_len). Only Ethernet TX allocations reserve that space: net_pkt_alloc_buffer() invokes the L2 alloc hook (ethernet_l2_alloc()) only when is_pkt_tx() is true and the packet's interface is the Ethernet interface. A packet that was allocated by a different L2 and then handed to Ethernet for transmission therefore has too little (usually zero) headroom. Such packets are produced by ordinary routing and tunnelling paths: net_route_packet_if() re-targets a received packet to another interface when CONFIG_NET_IPV4_FORWARDING / CONFIG_NET_IPV6_FORWARDING are enabled (for example an 802.15.4/OpenThread or PPP interface forwarding to Wi-Fi/Ethernet), net_route_ipv6_mcast_forward_packet() forwards an RX-slab clone that carries no reserve, and the IPIP tunnel interface_send() prepends an outer IP header allocated on the virtual interface. In these configurations a remote or adjacent attacker triggers the condition simply by sending traffic that the device forwards. Because net_buf_simple_push() only asserts on the headroom bound, a build without CONFIG_ASSERT (and without the newer CONFIG_NET_BUF_HARDENING) moves the fragment data pointer below the start of its data block and writes 14 bytes — 18 with VLAN — of Ethernet header out of bounds. With the default fixed-size buffer pools this overwrites the tail of the neighbouring buffer's payload or memory preceding the pool array; with variable-size pools it overwrites the buffer reference count and the heap chunk header. The attacker controls neither the written bytes nor the offset, so the practical impact is memory corruption leading to a crash, packet corruption, or heap inconsistency rather than controlled code execution. The fix takes the in-place path only when net_buf_headroom(pkt->buffer) is large enough and otherwise falls back to a separate header fragment.
Executive briefing
The source record describes: ethernet_fill_header() in subsys/net/l2/ethernet/ethernet.c can prepend the Ethernet header in place, by pushing it into the headroom of the packet's first fragment, instead of allocating a separate header fragment. Before this fix the in-place path was selected purely from the build-time value of CONFIG_NET_L2_ETHERNET_RESERVE_HEADER, with no check that the packet actually has that headroom, and then called net_buf_push(pkt->buffer, hdr_len). Only Ethernet TX allocations reserve that space: net_pkt_alloc_buffer() invokes the L2 alloc hook (ethernet_l2_alloc()) only when is_pkt_tx() is true and the packet's interface is the Ethernet interface. A packet that was allocated by a different L2 and then handed to Ethernet for transmission therefore has too little (usually zero) headroom. Such packets are produced by ordinary routing and tunnelling paths: net_route_packet_if() re-targets a received packet to another interface when CONFIG_NET_IPV4_FORWARDING / CONFIG_NET_IPV6_FORWARDING are enabled (for example an 802.15.4/OpenThread or PPP interface forwarding to Wi-Fi/Ethernet), net_route_ipv6_mcast_forward_packet() forwards an RX-slab clone that carries no reserve, and the IPIP tunnel interface_send() prepends an outer IP header allocated on the virtual interface. In these configurations a remote or adjacent attacker triggers the condition simply by sending traffic that the device forwards. Because net_buf_simple_push() only asserts on the headroom bound, a build without CONFIG_ASSERT (and without the newer CONFIG_NET_BUF_HARDENING) moves the fragment data pointer below the start of its data block and writes 14 bytes — 18 with VLAN — of Ethernet header out of bounds. With the default fixed-size buffer pools this overwrites the tail of the neighbouring buffer's payload or memory preceding the pool array; with variable-size pools it overwrites the buffer reference count and the heap chunk header. The attacker controls neither the written bytes nor the offset, so the practical impact is memory corruption leading to a crash, packet corruption, or heap inconsistency rather than controlled code execution. The fix takes the in-place path only when net_buf_headroom(pkt->buffer) is large enough and otherwise falls back to a separate header fragment. The practical risk depends on whether an affected product/version is present, reachable and configured in an exploitable way. Review the affected-product evidence and linked vendor advisories before assigning exposure status.
Evidence confidence: Limited Evidence-derived, not an exploitability verdict
Severity & attack characteristics
CVSS vector:CVSS:3.1/AV:N/AC:H/PR:N/UI:N/S:U/C:N/I:L/A:H
Technical explanation & impact
The technical mechanism is not expanded beyond the source description unless a referenced advisory supplies additional evidence. Read the linked vendor/CERT advisories for root-cause detail.
Potential impact must be interpreted from the published CVSS impact metrics and the affected component. A CVSS impact score is not proof that a particular asset is exploitable.
Weakness classification
CWE-787Affected products and versions
NVD has not supplied machine-readable vulnerable CPE product/version entries for this CVE. This is an information gap, not proof that no products are affected. Check the vendor advisory references below.
Remediation & validation
- Identify exposure by comparing the affected product and version ranges with your asset inventory, SBOM and externally exposed services.
- Review the linked vendor security advisory or patch notes. Upgrade to a vendor-confirmed fixed release; do not infer a fixed version from the CVE description.
- Until patched, consider restricting network access or disabling the affected feature where operationally safe. These are temporary controls, not a substitute for a vendor fix.
- Validate the remediation with a version check and vulnerability rescan, then retain change evidence.
No fixed version is displayed unless it is explicitly established by a vendor advisory. Follow the vendor's release notes for exact product and branch applicability.
Vendor advisories, patches & exploit references
- https://github.com/zephyrproject-rtos/zephyr/commit/b39f86ea61d0a0fdd7e9f145110649394e2c22ca VENDOR vulnerabilities@zephyrproject.org
- https://github.com/zephyrproject-rtos/zephyr/security/advisories/GHSA-56gp-jq94-c9hh VENDOR vulnerabilities@zephyrproject.org
Information gaps & confidence notes
These gaps indicate missing source data. CVE Watch does not fill them with guessed product, exploit or patch details.
- NVD does not currently provide machine-readable vulnerable CPE product/version entries for this record.
Last enrichment: 2026-11-05T17:42:53+00:00 · Source last modified: 2026-11-05T17:18:21.837